Vol. 4 No. 5 (2018) · Articles
Prof. M. K. Khunti
Mechanical Department, Government Eng., College, Rajkot, IN
Keywords: Shaft, Gear and Pinion, stress, FEA, CREO
The work is mainly concentrated about the analysis of a shaft with the help of a software ANSYS 15.0 workbench. In this the shaft is taken from the PTO shaft gear drive of Field Marshal make mini tractor. In this analysis the shaft is connected with gear and pinion. This is the major important component to be taken into account while designing. The objective is to build a model and assemble the part files and to analyze the various stress and deformation. The part files and assembly are done by using CREO software and the analyzing are done by using a ANSYS software. The static analysis is used to analyze the stress and deformation of the shaft when it is subjected to a particular load. The results obtained by the stress analysis is found to be good agreement with analytical stress value and modal analysis i.e., stresses and deformation presented are within the limit
NA
Prof. M. K. Khunti, “Finite Element Analysis of a Shaft of PTO drive subjected to a load,” International Journal of Technical Innovation in Modern Engineering & Science, vol. 4, no. 5, pp. 575-579, May 2018.
Copyright (c) 2018 Prof. M. K. Khunti
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Submission of a manuscript implies that the work described has not been published before, that it is not under consideration for publication elsewhere, and that if accepted, the author retains copyright with no restrictions. Authors may post the final peer-reviewed manuscript (postprint) to any repository or website.
